The complete solar power system consists of a solar panel, an inverter, and a battery. These three components works in synchronisation with each other to generate energy from sunlight. Most homeowners are going for solar power installation. Say you connect the solar panel installed at your home by the best solar panel installers in Sydney to the battery for charging. However, you find that the solar battery is not getting charged by the solar panel.
Some possible reasons and solutions for the solar panel not charging batteries are as follows:
Solar Panel Charge Controller Troubleshooting
The solar charge controller manages the power going into the battery from the solar panels. If the solar charge controller is broken, the battery won’t charge. Usually, this happens in the case of charge controllers of inferior quality. In addition to this, the charge controller may malfunction and face problems such as display freeze, no power, etc.
Solutions
If there is an error, or the controller is not functioning properly, you can perform a soft reset. If still, the problem persists, you can try the hard reset as well. Resetting the solar charge controller is one of the easiest ways to fix it. If the charge controller is broken, you need to get it replaced by one of the solar panel installers in Sydney.
Faulty Solar Panel
Another possible reason why the solar panel is not charging the battery may be a faulty solar panel. Although the solar panel is designed to resist any possible damage, it may develop a fault as electrical equipment.
Some of the possible faults of solar panels include:
1. Hot spots
2. Broken diode
3. Micro cracks
4. Unusual reaction (patterns)
5. Old or inferior quality panels
6. Snail trail contamination
7. PID (Potential Induced Degradation) effect
8. Internal corrosion
Solutions
1. Check whether the terminals are not reversed.
2. Ensure that shadows or weather are not obstructing the panel.
3. Check the specifications of the panel
4. If you notice micro-cracks, weird patterns, or hot spots, it is time to contact solar panel installers for replacement.
Incorrect Setup
An incorrect setup of the solar panel, charge controller, and battery means that the solar system will be non-functional.
An incorrect setup include any of the following:
1. Improper connection
2. Bad connections
3. Directly connecting panels to batteries
4. Open circuit and voltage mismatch
5. Messing up of anode and cathode
Incorrect setup also includes environmental factors such as extreme weather conditions like shade, insufficient sunlight, etc.
Solutions
It is crucial to set up the system correctly and have good-quality equipment. In the case of a complex solar system, it is best to take the help of the best solar panel installers in Sydney. Ensure that the solar panel is getting sufficient sunlight and not being obstructed by trees.
Faulty Battery
A broken battery will not charge. Also, it is important not to attempt charging batteries that are incompatible with the solar panel. Keeping the battery idle for a long time without charging means direct charging with a solar panel won’t work.
Solutions
1. Don’t use broken or old batteries.
2. Check the voltage of the battery.
3. Replace badly damaged and incompatible batteries.
4. Recharge the battery if the voltage is low.
A solar panel not charging the battery is a common issue faced by many who have opted for solar panel systems. If you are unsure of what has occurred, it is best to contact expert solar panel installers in Sydney to inspect the system.
Read Next Blog:
